Hardware Support

  • Contact support
  • Contact sales
  • Trial software

NI myDAQ Support from MATLAB

Low cost data acquisition platform for measuring and analyzing signals.

MATLAB supports National Instruments myDAQ (NI myDAQ) hardware, a low-cost, portable USB DAQ device. NI myDAQ hardware is used for project-based learning and hands-on experimentation for analog circuits, sensors, signals, and systems.

Support for NI myDAQ hardware is included in the Data Acquisition Toolbox and allows you to perform the following tasks in MATLAB starting with R2012a:

  • Read data from analog input channels (oscilloscope)
  • Write data to analog output channels (function generator)
  • Read and write data to the eight digital input and output channels
  • Setup and configure the NI myDAQ Counter/Timer
  • Configure the sampling rate of the NI myDAQ device
Configuring a data acquisition session using NI myDAQ hardware.

Requirements

Software

Required

Supported in student and home software.

Recommended

Support Package

Required

Support for NI myDAQ is built into Data Acquisition Toolbox. No separate support package is required.

Hardware

Required

Software

Required