## Documentation Center |

On this page… |
---|

If you combine different integer types in a matrix (e.g., signed
with unsigned, or 8-bit integers with 16-bit integers), MATLAB^{®} returns
a matrix in which all elements are of one common type. MATLAB sets
all elements of the resulting matrix to the data type of the left-most
element in the input matrix. For example, the result of the following
concatenation is a vector of three 16-bit signed integers:

A = [int16(450) uint8(250) int32(1000000)]

MATLAB also displays a warning to inform you that the result may not be what you had expected:

A = [int16(450) uint8(250) int32(1000000)]; Warning: Concatenation with dominant (left-most) integer class may overflow other operands on conversion to return class.

You can disable this warning by entering the following two commands directly after the operation that caused the warning. The first command retrieves the message identifier associated with the most recent warning issued by MATLAB. The second command uses this identifier to disable any further warnings of that type from being issued:

[msg, intcat_msgid] = lastwarn; warning('off', intcat_msgid);

To re-enable the warning so that it will now be displayed, use

warning('on', intcat_msgid);

You can use these commands to disable or enable the display of any MATLAB warning.

After disabling the integer concatenation warnings as shown above, concatenate the following two numbers once, and then switch their order. The return value depends on the order in which the integers are concatenated. The left-most type determines the data type for all elements in the vector:

A = [int16(5000) int8(50)] A = 5000 50 B = [int8(50) int16(5000)] B = 50 127

The first operation returns a vector of 16-bit integers. The
second returns a vector of 8-bit integers. The element `int16(5000)` is
set to `127`, the maximum value for an 8-bit signed
integer.

The same rules apply to vertical concatenation:

C = [int8(50); int16(5000)] C = 50 127

Now do the same exercise with signed and unsigned integers. Again, the left-most element determines the data type for all elements in the resulting matrix:

A = [int8(-100) uint8(100)] A = -100 100 B = [uint8(100) int8(-100)] B = 100 0

The element `int8(-100)` is set to zero because
it is no longer signed.

MATLAB evaluates each element *prior to* concatenating
them into a combined array. In other words, the following statement
evaluates to an 8-bit signed integer (equal to 50) and an 8-bit unsigned
integer (unsigned -50 is set to zero) before the two elements are
combined. Following the concatenation, the second element retains
its zero value but takes on the unsigned `int8` type:

A = [int8(50), uint8(-50)] A = 50 0

Was this topic helpful?